Pool Light - #PL

Path Light

Pool Light #PL - IP68

This luminaire is electro- polished, and is supplied with a multi-purpose PVC mounting canister. It can be installed in three different types of pool wall:
1) Fibreglass Pools, 2) Existing Concrete Pools, 3) New Concrete Pools.

The luminaire is held into the Wet Niche PVC canister by two 'O' rings. This means there are no mounting screws in the flange to spoil the aesthetics of the luminaire. Up to 600mm of cable can be coiled up inside the mounting canister, enabling lamp changing above the water line.

The Pool Lite is machined from 9mm thick 316 stainless steel with a tempered glass lens, high temperature silicon gaskets, and is supplied with an engineering grade PVC mounting canister (wet niche).

Complete with six metres of submersible cable (other lengths available on request).
Suitable for use with MR16 - 20, 35, 50 watt lamps and is supplied with a high quality European 5000 hour lamp. Lifetime Warranty on Lens Breakage.

Accessories: Cable Joint Kit #CJK150, Frosted Lens #DFL, Hex Cell Louvre Adaptor #HCL.

Power Supply - HUNZA® H20, H40 and H50 for internal mounting only. .Check with your Local Electrical Authority for pool zone installation regulations.

Warning - out of balance pool chemicals may cause the fitting to corrode at a rapid rate. In the case of salt water an increase in water temperature of 10 degrees will double the corrosion factor. 316 stainless steel is suitable for situations of up to 1000 parts per million of chloride. Where an automatic chlorinator is employed an excess amount of chlorine may be produced.

The Hunza® Pool Lite is electro- polished, this finish increases the protection against corrosion by up to 33%.

 

 

 
Path Light
Click on Images to Enlarge
Download Spec Sheet

Price:

Pool Light
Stainless Steel: £330.24

Including VAT